Release Notes
Remote Workstation Card Firmware 5.1.0
What's New
Custom certificate support for direct connections to Remote Workstation Card
PCoIP Zero Clients can be paired to PCoIP Remote Workstation Cards using custom certificates to establish a secure PCoIP peer-to-peer connection.
Note: Best security practice
Teradici highly recommends using this new feature to create a more secure environment. Contact your IT department to ensure your deployment is in accordance with your Company's security policy.
Compatibility
| Compatibility Notes | Platforms | Platforms | Clients | Clients |
| VMware Horizon |
Teradici Cloud Access Software |
PCoIP Zero Client |
PCoIP Software Clients |
|
|
This firmware release is supported when connected to PCoIP Zero Clients on firmware 6.2.0. Note: Other zero client firmware may be compatible with this release, but are not supported. |
X | |||
|
This firmware release is supported when connected to PCoIP Software Client 3.8.1. Note: Other client versions may be compatible with this release, but are not supported. |
X | |||
|
Management requires a compatible endpoint manager such as PCoIP Management Console release 3.1 or higher. |
X | |||
| This firmware release is supported with the VMware broker and security gateway available in Horizon View 7.6. | X | |||
|
This release cannot be brokered in use with the Teradici Cloud Access Software. This release cannot be brokered using the CMI brokering protocol. |
None
Frequent webpage reloading shows different content in Chrome
When using Chrome, performing frequently or fast webpage reloading can result in portions of an AWI page that are not normally visible to become visible. This has not been observed on Firefox or Edge.
Internet Explorer 11 does not trust the Administrative Web Interface certificate
Internet Explorer 11 does not trust the Administrative Web Interface certificate if the AWI is accessed via IP address (it will trust the certificate when using the FQDN).
Profile application to a Remote Workstation Card fails when Enable Audio has not been enabled
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the Enable Audio setting enabled since the last Reset Parameters setting has been applied.
In either case, after attempting to apply the profile, the PCoIP Management Console may display incorrect statuses of the endpoint. For example, if the profile attempted to peer the Remote Workstation Card to a PCoIP Zero Client, the status will display as peered when the Remote Workstation Card may be in a state ready to accept any connection.
To make sure your profile is applied to the Remote Workstation Card correctly, ensure the *Enable Audio* setting has been enabled in the profile you are applying or ensure the setting has been enabled once prior to applying a new profile.