Why does my Tera2 PCoIP Zero Client perform poorly on a WAN, compared to a software client on the same network?
If you are experiencing refresh issues of image data when scrolling through text and/or images using a PCoIP Zero Client on a WAN network, ensure that you enable the Low Bandwidth Text Codec (LBTC) setting. Note: The LBTC setting is available on TERA2321 …
Why is my 802.1x configuration failing on my older network?
Scenario 1 In an environment that contains legacy network equipment, after setting up 802.1x, initial authentication fails. The authentication switch does not respond to any of the EAP-TLS request packets from the PCoIP Zero Client.   Cause Some legacy …
Cannot connect to the web interface (AWI) of a zero client or remote workstation card after changing the Label name.
Scenario You modify the label name of your zero client or remote workstation card and after reboot you cannot connect to the web interface using the FQDN. For example the default label name may be similar to pcoip-portal-0030040c8f2d You modify it to …
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
PCoIP TROUBLESHOOTING STEPS: IEEE 802.1x Network Authentication
This article provides a brief list of troubleshooting steps for common issues with 802.1x authentication. It is not intended to be a comprehensive troubleshooting guide. These include scenarios for: Problems uploading IEEE 802.1x certificates to PCoIP …
The VMware Horizon View PCoIP server logs show "IPC Can't encode. Waiting. queue" after a random disconnect.
Problem The VMware Horizon View Client or PCoIP Zero Client experience a random disconnect from the VMware Horizon View session. Inspection of the PCoIP server logs show a high slice rate count after a random disconnect. The following example shows 192 …
Why do my PCoIP Zero Clients randomly disconnect after upgrading to firmware 3.5.x to Firmware 4.8.1?
Scenario PCoIP Zero Clients randomly disconnect (approximately every 15-20 minutes) from the PCoIP session. In PCoIP Zero Client log file you can find the following lines: 0d,00:02:15> LVL:2 RC: 0 GSOAP :SOAP 1.2 fault: SOAP-ENV:Sender [no subcode] …
PCoIP Management Console 2.x and 3.x is not loading pages properly when accessing the web interface via the FQDN
Problem Using fully qualified domain name (FQDN) in your browser to access the PCoIP Management Consoles web interface displays only a portion of the page. Using the IP address, the web interface page is displayed properly and user is prompt for user name …
Recommend upgrading LLS 21.03 or earlier to the latest LLS to avoid service disruption
Our third-party license provider is upgrading certificates in March 2023 If you are running a  supported  HP Anyware Local License Server (LLS) or using the Cloud License Service (CLS), you will not be impacted by these changes.  The new certificates are …