My PCoIP Zero Clients at the remote location cannot connect to PCoIP Management Console 3.x
Problem PCoIP Zero Clients in remote locations are not connecting to the PCoIP Management Console 3.x   Cause This issue was tracked down to a setting in the PCoIP Management Console 3.x (MC). Check under Settings > Remote and confirm if you have entered …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: November 7, 2022
885
Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 22, 2022
880
What PCoIP GPO settings in VMware Horizon View take effect immediately after the change is made?
Answer: There are currently 4 GPO settings which changes take effect immediately. These are available in Horizon View 5.2 and are listed below along with links to the individual GPO descriptions. In Horizon View 5.3 an additional GPO was added to this …
Knowledge Base Article Advisory Setup Performance Third Party Enhancements Zero Clients
Last modified: September 3, 2023
870
"No PCoIP Device Detected." when installing the PCoIP Host Software in a Dell r7910 Precision Workstation
On the Dell 7910 Precision Workstation there are 7 PCIe slots, 1 to 4 are powered by the CPU2 and 5 to 7 are powered by CPU1. When there is only one CPU, the PCoIP Remote Workstation Card will need to be installed in the correct PCIe slot. Please note : …
Knowledge Base Article Troubleshooting Setup Remote Workstation Card
Last modified: July 31, 2023
865