Is there any bandwidth consumed when a PCoIP device is idle?
The idle bandwidth depends on the PCoIP host type. Below are the idle bandwidths for different host types: HP Anyware 2.12 and newer, the idle bandwidth consumed is 1-2 kbps. VMware View 4.5 (using PCoIP Software 3.5) and earlier, the idle bandwidth …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
231
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
Knowledge Base Article Troubleshooting Session Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 7, 2023
224
Windows Legal Disclaimer and HP Anyware: A short guide to understand the impact of a Windows Legal Disclaimer with HP Anyware
What is a Windows legal disclaimer? A Windows legal disclaimer is a statement that appears on the screen when you start your computer or install a new Windows operating system. It informs you of the terms and conditions of using Windows and the rights and …
Knowledge Base Article Advisory Troubleshooting FAQ Diagnostics Accounts HP Anyware
Last modified: June 24, 2024
217
Management Console profile with blacklisted ciphers fails to apply to Remote Workstation Card
If a Management Console profile is configured to blacklist any of the following Remote Workstation Card ciphers, the profile application will fail on Remote Workstation Cards running firmware 21.01 or newer. TLS_RSA_WITH_AES_256_GCM_SHA384 …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: September 3, 2023
211
What does the "i2c should be 0x03 on cable detect" PCoIP Zero Client event log error indicate?
Answer: Faulty cables interfere with the mechanisms in which PCoIP detects displays and can present a variety of errors. The i2c should be 0x03 on cable detect  PCoIP Zero Client log errors are usually indicative of faulty cables and occasionally of …
Knowledge Base Article Troubleshooting Zero Clients
Last modified: September 20, 2023
205