How many characters are supported in the PCoIP Zero Client Pool (Desktop) Name to Select field?
Answer: On a PCoIP Zero Client, when selecting any of the View Connection Server options for the Connection Type other than View Connection Server + Kiosk, the advanced button will present an option called Pool Name to Select.  (Note, in older versions of …
Knowledge Base Article Advisory Zero Clients
Last modified: September 25, 2023
316
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
312
PCoIP Firmware 4.0.2 Issue Notification
Scenario There is an issue with firmware 4.0.2 where the use of the PCoIP Management Console 1.8.0 could result in rendering the Tera2 zero client non-functional and non-recoverable. This issue may be encountered intermittently when deploying profiles …
Knowledge Base Article Advisory Zero Clients
Last modified: August 7, 2023
314
Can I share the network connection of the PCoIP Remote Workstation Card with that of the host PC/workstation?
No, the network interface on the PCoIP Remote Workstation Card is independent to that of the host. It is not possible to communicate to the host operating system via the PCoIP Remote Workstation Card network interface. Therefore, you must connect both the …
Knowledge Base Article Advisory Setup Remote Workstation Card
Last modified: July 3, 2020
302
Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
304
Disable IPv6 in HP Anyware agent
IPv6 is enabled by default in HP Anyware agent starting agent 21.07 release.    Disable IPv6 (Only IPv4 connection is allowed)   Windows agent Open  Registry Editor .  Add registry value under   …
Knowledge Base Article Advisory Setup HP Anyware
Last modified: September 3, 2023
301
Can I constrain PCoIP bandwidth usage to fit my network?
The maximum PCoIP bandwidth usage an be configured per a session. When restricting the maximum PCoIP session bandwidth, the frame rate and image quality maybe reduced due to the reduction in bandwidth. For limiting PCoIP Zero Clients see: PCoIP Zero …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
298
What is Intelligent Packet Re-Transmission in PCoIP Protocol?
PCoIP Protocol uses UDP protocol similar to other real-time protocols (voice-over-IP, interactive video conferencing etc).  This is done to minimize the overhead associated with TCP protocol.  However, reliable transmission of data is important for remote …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
281