Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card
Last modified: November 8, 2020
271
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 18, 2022
274
Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
267
What are the priorities for video, audio, and USB PCoIP traffic?
PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …
Knowledge Base Article Advisory Performance Peripheral Devices HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
258
Does the PCoIP Zero Client have left hand mouse configuration settings?
The PCoIP Zero Client currently has no specific left hand mouse setting. The PCoIP Zero Client configuration options in the OSD were designed to negate the necessity for right hand or left hand functionality therefore both buttons act the same. Right hand …
Knowledge Base Article Advisory Peripheral Devices Zero Clients
Last modified: September 3, 2023
255
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
258