What network switch or router queue size should be used?
Network device queues, also known as network buffer's, should be configured to accommodate 50ms to 100ms of PCoIP protocol traffic in total. This assumes that one network device (e.g. switch or router) is congested for a given network path. If the network …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 19, 2023
864
What is the DHCP request timeout on a PCoIP Zero Client or PCoIP Remote Workstation Card?
The PCoIP Zero Client and PCoIP Remote Workstation Card will attempt to get a DHCP lease 4 times after power on or after the network link comes up. When a PCoIP device is connected to a network with no DHCP server and the DHCP request time-out period …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
842
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support HDMI connections?
PCoIP zero clients only come with the following connections: sVGA DVI (single and dual link) Display Port (1.1a) HDMI is not a supported connector type on PCoIP Zero Clients. You can purchase Display Port or DVI to HDMI cables and adapters however you may …
Knowledge Base Article Advisory Display Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2023
808
Connecting a new PCoIP Zero Client to an existing PCoIP Remote Workstation Card.
In general, newer firmware in PCoIP Remote Workstation Cards (host cards) are backward compatible with PCoIP Zero Clients using older firmware. However, enhancements to firmware may produce unexpected behaviors. Important changes are documented in each …
Knowledge Base Article Troubleshooting Session Remote Workstation Card Zero Clients
Last modified: September 19, 2023
793
What are the possible reasons for jitter on a 30 inch monitor when compared to a 24 inch monitor connected to the same Tera2 Remote Workstation Card?
Problem In a single workstation environment when comparing a 30 inch monitor at 2560x1600 to a 24 inch monitor at 1920x1600, moving a window containing a running video in the 30 inch screen shows latency and window drag when compared to the 24 inch …
Knowledge Base Article Troubleshooting Display Performance Remote Workstation Card
Last modified: December 9, 2022
787
How does competing traffic on the network affect PCoIP performance?
This article outlines how other types of network traffic may negatively impact PCoIP performance. Please refer to  Network session checklist for PCoIP protocol LAN and WAN deployments  for more details on network configuration. On most modern LAN's, …
Knowledge Base Article Tutorial Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
775
How to configure a PCoIP Zero Client to auto-connect to a Remote Workstation Card
Answer: To enable auto connect, you need to peer the PCoIP Zero Client to the Remote Workstation Card. You will need the IP and MAC of the host. You enter this in the PCoIP Zero Client's configuration (On Screen Display or Administrative Web Interface), …
Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
753
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
690