Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 22, 2022
759
Upgrading from firmware 3.4.x or earlier, a message displays indicating my USB devices failed authorization
Problem When upgrading PCoIP Zero Client firmware from 3.4.x, USB locally terminated devices work, but no redirected (bridged) USB devices work. When viewing attached devices in the Administrator Web Interface (AWI) only the mouse and keyboard show as …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: September 25, 2023
723
My PCoIP Zero Clients at the remote location cannot connect to PCoIP Management Console 3.x
Problem PCoIP Zero Clients in remote locations are not connecting to the PCoIP Management Console 3.x   Cause This issue was tracked down to a setting in the PCoIP Management Console 3.x (MC). Check under Settings > Remote and confirm if you have entered …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: November 7, 2022
720
"No PCoIP Device Detected." when installing the PCoIP Host Software in a Dell r7910 Precision Workstation
On the Dell 7910 Precision Workstation there are 7 PCIe slots, 1 to 4 are powered by the CPU2 and 5 to 7 are powered by CPU1. When there is only one CPU, the PCoIP Remote Workstation Card will need to be installed in the correct PCIe slot. Please note : …
Knowledge Base Article Troubleshooting Setup Remote Workstation Card
Last modified: July 31, 2023
717
What are the possible reasons for jitter on a 30 inch monitor when compared to a 24 inch monitor connected to the same Tera2 Remote Workstation Card?
Problem In a single workstation environment when comparing a 30 inch monitor at 2560x1600 to a 24 inch monitor at 1920x1600, moving a window containing a running video in the 30 inch screen shows latency and window drag when compared to the 24 inch …
Knowledge Base Article Troubleshooting Display Performance Remote Workstation Card
Last modified: December 9, 2022
716
DNS errors in the event log of the PCoIP Zero Client running firmware 5.x and 6.x.
Problem The PCoIP Zero Client event log contains these entries ever 5 minutes. -510    MGMT_DISC_DNS :conduct_dns_record_search: ( DNS SRV: CMS ) DNS record not found -510    MGMT_DISC_DNS :conduct_dns_record_search: ( DNS SRV: Config Tool ) DNS record …
Knowledge Base Article Troubleshooting Zero Clients
Last modified: September 19, 2023
714
How do I improve performance when dragging a window on the screen using firmware pre-4.1.0 and without a PCoIP Hardware Accelerator installed?
Problem While there are many factors that determine desktop performance - see  PCoIP TROUBLESHOOTING STEPS: VMware View Virtual desktop performance  - lower performance of window dragging may be observed in the following environment: VMware Horizon View …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: November 18, 2022
676
Why do I still see VDM Server Address Cache addresses after clearing the Trusted Connection Server Cache?
Answer: The VDM Server Address Cache is a list of servers that are populated either manually from the AWI and OSD or via a Profile push from the Management Console. This field value can be set to either Last Server Used or Read Only. If set to Last Server …
Knowledge Base Article Troubleshooting Management Console Zero Clients
Last modified: September 19, 2023
673