HP Anyware Support | Documents, downloads, and support options for HP Anyware products

Sort by

Client Display Health Check - Diagnostics and troubleshooting guide

Summary To receive a detailed client diagnostic report, create a client support/log file bundle and then submit this bundle to the PCoIP health check tool. Once the files are submitted, it will take 5-10 minutes to produce a detailed report. The …

Knowledge Base Article Diagnostics Display HP Anyware

Last modified: September 3, 2023

1494

How do I identify if enhanced logging is enabled on PCoIP Zero Clients and PCoIP Remote Workstation cards?

Answer: Since firmware 4.0.0, enhanced logging has been identifiable in events logs on PCoIP Zero Clients and PCoIP Remote Workstation Cards (also known as a host card). Event log entries of no module selected indicate enhanced logging is not activated …

How to tune PCoIP for bandwidth constrained Network?

Bandwidth Tuning To determine if bandwidth tuning is required, setup a PCoIP session and monitor the performance of your system. The values to record are latency, latency variation, packet loss and tx and rx statistics. For details on how to run these …

Why is the BIOS not accessible from my PCoIP Workstation solution?

The BIOS must be able to enumerate the PCIe PCoIP Remote Workstation Card and support OHCI which typically does not occur until post BIOS. USB peripherals (keyboard, mouse etc.) connected to PCIe PCoIP Remote Workstation Cards as in a PCoIP Workstation …

How much bandwidth does PCoIP require?

The simple answer is 'it depends'. The amount of bandwidth required depends on a number of factors (display resolution, frame rate, graphical intensity for the user, importance of image quality, amount of display interactivity vs static viewing). Due to …

Mirroring displays on PCoIP Zero Clients

Requirements Tera2 dual port client (TERA2321) Firmware 4.1 or newer Instructions From the PCoIP Zero Client's onscreen display (OSD) or both versions of the Management Console OSD - browse to Options > Configuration > Display > Enable Display Cloning …

Knowledge Base Article Tutorial Display Zero Clients

Last modified: November 7, 2022

1455

How do I enable IEEE 802.1x Network Authentication in PCoIP Zero Clients and PCoIP Remote Workstation Cards?

1) Identify the certificates used for IEEE 802.1x network authentication in your organization 2) Ensure that the certificates are properly formatted Certificates must be in .PEM format and less than 6 KB Both a client certificate and a server root CA …

What does "Could not send message to FNE license server" mean?

Problem The PCoIP Graphics Agent for Windows or PCoIP Standard Agent for Windows fails to register to the cloud licensing server or your PCoIP session disconnects shortly after connect. Symptoms When trying to register the host to a cloud license server …

This firmware version is not supported on this platform. Please upload a different file

Problem When attempting to downgrade firmware the error message This firmware version is not supported on this platform. Please upload a different file Or in the PCoIP Remote Workstation Card or PCoIP Zero Client event log 0d,00:03:36.19> LVL:2 RC: 0 …

What is the difference between local and remote cursor in the PCoIP Host Software?

Local cursor Local cursor draws the mouse pointer locally at the client which improves the user experience when the client is connected over a long latency network. The improvement is due to the client sending the mouse coordinates to the remote host and …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics