No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
324
How can I tell which monitors are connected and if a USB device is connected locally or bridged on a PCoIP Zero Client?
Answer: From your Web browser, enter the IP address of your PCoIP Zero Client. Log in to the user interface with your user credentials. (Note: Depending on your specific setup, a password may not be required.) From the Info menu, select Attached Devices . …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: October 31, 2022
317
Local Administrative Password setting is disabled after changing the firmware version in the profile in the PCoIP Management Console 3.0.0
Problem After changing the firmware version in a profile in PCoIP Management Console 3.0.0 the Local Administrative Password setting is no longer enabled and the password field is blank.   Cause This issue is known to happen when the following conditions …
Knowledge Base Article Troubleshooting Security Management Management Console
Last modified: November 7, 2022
310
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
311
Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
306
Why can I not establish a PCoIP session when using (IDN) characters in my HP Anyware environment?
Answer: Internationalized Domain Names (IDNs) are not supported by the HP Anyware. In environments that use the HP Anyware PCoIP Connection Manager and Security Gateway, a PCoIP session will not launch when one or more IDN characters (i.e. ? ? ? ?) are …
Knowledge Base Article Troubleshooting Session HP Anyware
Last modified: September 19, 2023
308
Unable to start docker containers connector_cm and connector_connectorgateway during HP Anyware Connector installation
In Ubuntu 18.04.4 LTS or Ubuntu 18.04.5 LTS setting up HP Anyware Connector, if IPV6 was disabled in the vm  those 2 containers will always fail to start. During the installation or reinstallation of the HP Anyware Connector, connector_cm and …
Knowledge Base Article Troubleshooting Setup Management HP Anyware
Last modified: September 14, 2023
302