Why does my Tera2 PCoIP Zero Client perform poorly on a WAN, compared to a software client on the same network?
If you are experiencing refresh issues of image data when scrolling through text and/or images using a PCoIP Zero Client on a WAN network, ensure that you enable the Low Bandwidth Text Codec (LBTC) setting. Note: The LBTC setting is available on TERA2321 …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: August 2, 2023
505
No audio when using Unified Communications with a USB headset
Problem Some users have reported no audio when using Unified Communications solution in firmware 4.7.0, they can only hear the ring of the incoming call and when the call is answered there is no Rx/Tx audio.   Cause This issue has been tracked down to the …
Knowledge Base Article Troubleshooting Performance Peripheral Devices Zero Clients
Last modified: November 7, 2022
501
When does the PCoIP Management Console apply a resolution change using the Enable Preferred Resolution Override setting while in a PCoIP session?
In PCoIP Management Console (MC) 1.9.1 (and newer), PCoIP Zero Clients with firmware 4.1.2 (and newer) can be configured to override the attached monitors native resolution using the Enable Preferred Resolution Override feature. The setting is recognized …
Knowledge Base Article Troubleshooting Management Display Management Console Zero Clients
Last modified: September 3, 2023
504
Why is my 802.1x configuration failing on my older network?
Scenario 1 In an environment that contains legacy network equipment, after setting up 802.1x, initial authentication fails. The authentication switch does not respond to any of the EAP-TLS request packets from the PCoIP Zero Client.   Cause Some legacy …
Knowledge Base Article Troubleshooting Security Remote Workstation Card Zero Clients
Last modified: November 23, 2022
498
What does "IPC: Frame encode took xxx ms so far. Dropping down the quality to index x." in the log files indicate?
Answer: In this case, the imaging encoder has determined that too many bits were being sent in the upper portion of the frame (i.e. flooding) which causes the frame to take longer to encode, and therefore appears unresponsive to the user (> 750 ms to …
Knowledge Base Article Troubleshooting Performance HP Anyware Zero Clients Remote Workstation Card
Last modified: December 9, 2022
498