My PCoIP Zero Clients at the remote location cannot connect to PCoIP Management Console 3.x
Problem PCoIP Zero Clients in remote locations are not connecting to the PCoIP Management Console 3.x   Cause This issue was tracked down to a setting in the PCoIP Management Console 3.x (MC). Check under Settings > Remote and confirm if you have entered …
Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
"No PCoIP Device Detected." when installing the PCoIP Host Software in a Dell r7910 Precision Workstation
On the Dell 7910 Precision Workstation there are 7 PCIe slots, 1 to 4 are powered by the CPU2 and 5 to 7 are powered by CPU1. When there is only one CPU, the PCoIP Remote Workstation Card will need to be installed in the correct PCIe slot. Please note : …
Upgrading from firmware 3.4.x or earlier, a message displays indicating my USB devices failed authorization
Problem When upgrading PCoIP Zero Client firmware from 3.4.x, USB locally terminated devices work, but no redirected (bridged) USB devices work. When viewing attached devices in the Administrator Web Interface (AWI) only the mouse and keyboard show as …
What are the possible reasons for jitter on a 30 inch monitor when compared to a 24 inch monitor connected to the same Tera2 Remote Workstation Card?
Problem In a single workstation environment when comparing a 30 inch monitor at 2560x1600 to a 24 inch monitor at 1920x1600, moving a window containing a running video in the 30 inch screen shows latency and window drag when compared to the 24 inch …
DNS errors in the event log of the PCoIP Zero Client running firmware 5.x and 6.x.
Problem The PCoIP Zero Client event log contains these entries ever 5 minutes. -510    MGMT_DISC_DNS :conduct_dns_record_search: ( DNS SRV: CMS ) DNS record not found -510    MGMT_DISC_DNS :conduct_dns_record_search: ( DNS SRV: Config Tool ) DNS record …
How do I improve performance when dragging a window on the screen using firmware pre-4.1.0 and without a PCoIP Hardware Accelerator installed?
Problem While there are many factors that determine desktop performance - see  PCoIP TROUBLESHOOTING STEPS: VMware View Virtual desktop performance  - lower performance of window dragging may be observed in the following environment: VMware Horizon View …
Why do USB 2.0 or isochronous devices fail to work as expected when plugged into a Samsung NC220 or NC240 PCoIP monitor?
Answer: This occurs because on the NC220 and NC240 monitor series, USB Ports 0, 1 and 2 are brought out directly and port 3 is connected to an internal hub. On this hub, 1 hub port is connected to a RS232 device, and another hub port is connected to an …
Connecting a new PCoIP Zero Client to an existing PCoIP Remote Workstation Card.
In general, newer firmware in PCoIP Remote Workstation Cards (host cards) are backward compatible with PCoIP Zero Clients using older firmware. However, enhancements to firmware may produce unexpected behaviors. Important changes are documented in each …