Why does my Tera2 PCoIP Zero Client perform poorly on a WAN, compared to a software client on the same network?
If you are experiencing refresh issues of image data when scrolling through text and/or images using a PCoIP Zero Client on a WAN network, ensure that you enable the Low Bandwidth Text Codec (LBTC) setting. Note: The LBTC setting is available on TERA2321 …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: August 2, 2023
531
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
Knowledge Base Article Troubleshooting Display Performance Zero Clients HP Anyware
Last modified: August 2, 2023
527
Skipped compressing pkt due to PCM bit length in the PCoIP Remote Workstation Card Logs
Scenario User notices poor audio quality when connected to a PCoIP Remote Workstation Card (host card), and the following entries are in the PCoIP Remote Workstation Card's logs: 12/04/2013, 00:01:41> LVL:3 RC: 0 AUDIO_CMPRS :Skipped compressing pkt due …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: August 3, 2023
491
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
482
Why is Adobe Flash choppy with VMware Horizon View and PCoIP Zero Clients?
Answer: Note: This article only applies to VMware Horizon View desktops that do not have physical GPU acceleration. To optimize the performance of Flash, ensure that the Flash player has hardware acceleration turned off: Right click on the Flash window …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: December 9, 2022
433
Will out of order packets impact a PCoIP session?
PCoIP will work when packets are becoming out of order between the two PCoIP endpoints. Re-ordering packets on PCoIP endpoints requires that packets are held in a queue/buffer while waiting to receive the packets that need to be put back into order.  With …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
409
Why am I seeing high bandwidth from the PCoIP Zero Client for audio even though I am not recording anything?
Problem As soon as an audio application starts and samples data from the audio input, PCoIP traffic from the client to host increases significantly and is steady.   Cause Once an application requests audio from the line in or microphone inputs, the PCoIP …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: April 27, 2023
399
Why do I get poor performance on an MPLS network?
There are a number of configuration requirements for using PCoIP protocol on an MPLS network.  Prioritize PCoIP packets as a best practice Avoid packet loss Avoid out-of-order packets PCoIP protocol may consider out-of-order packets as lost if the data …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
364
How does PCoIP share bandwidth over the network?
The BW Limit is dynamically calculated and represents the bandwidth the PCoIP session estimates to be available given the network conditions. The calculation takes into account the existing bandwidth usage, packet loss and any high latency spikes. The …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
364