What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card Zero Clients
Last modified: May 1, 2025
3981
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3961
HP Anyware Agents, Clients and direct connections
After completing this unit, you’ll be able to: Understand the difference between different host and client environments Understand the system requirements for the installation of product Install the required product Establish a direct connection to the …
Knowledge Base Article Tutorial HP Anyware
Last modified: September 14, 2023
3869
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3732