How do I check for packet loss on the ESX interface?
If there is packet loss on a PCoIP protocol session, but an analysis of network devices in the path show no loss and they have been properly configured (see  Network session checklist for PCoIP protocol LAN and WAN deployments ) then you may want to …
Tools for PCoIP Protocol Deployments
This article provides links to tools that can be used for planning or troubleshooting HP Anyware, PCoIP Remote Workstation Card, Amazon Workspaces, and VMware Horizon View PCoIP deployments.   Network Bandwidth Calculator Useful for network bandwidth …
What are the network maximum transmission unit (MTU) requirements for PCoIP?
PCoIP maximum transmission unit (MTU) Requirements Every network has a MTU that dictates the maximum size a individual network packet can be for transmission. If the packet is larger than the MTU it will be fragmented and sent as multiple packets or …
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
PCoIP Audio quality and bandwidth
PCoIP Audio Features 2 channel Stereo audio Automatic quality adjustment to fit inside the available PCoIP session bandwidth Audio In and Audio Out via the HP Anyware Audio Driver included in the HP Anyware or ALC888 equivalent audio in the PCoIP Remote …
How to use the packet capture utility in PCoIP Zero Client Firmware
Since many customers are unlikely to have access to a port mirroring switch, a new packet capture feature was added in firmware 4.7.0. It is designed to assist with troubleshooting Unified Communications issues.   Note: The packet capture utility will not …
How can I determine the frame rate at a PCoIP protocol client?
Answer: There are a multiple ways to determine the frame update rate displayed at the PCoIP Zero Client.    Note: the frame rate displayed at the client this may be different than the source display frame rate when in a congested network environment.  Log …
How do I optimize the Windows 7 desktop experience settings to reduce PCoIP session bandwidth?
Answer: On a Microsoft Windows 7 machine, make the following change to the Windows optimization settings: Start > Computer > System Properties > Advanced System Properties > Performance Settings button > Adjust for best performance . Alternatively, you …
How do I change the image quality properties of a PCoIP Remote Workstation Card?
Review the below table to understand where to change the image quality properties in a remote workstation environment. This information applies to sessions between PCoIP Zero Clients and a PCoIP Remote Workstation Card (i.e. host card). If you are using a …
How to configure audio in a Linux workstation with a Tera1 or Tera2 Remote Workstation Card
Note: This knowledge base article covers older versions of Linux, newer modern versions Linux will automatically pick up the Audio device on the PCoIP Remote Workstation Card and activate the audio drivers. This knowledge base article has been made …