Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
291
Why is the PCoIP Management Console 1.9.0 and older slow to discover devices?
Answer: The PCoIP Management Console (MC) is tested to support up to 2000 devices. Some customers have deployed the MC and are supporting in excess of 2000 devices. Several customers in this scenario have reported that when trying to update devices the MC …
Knowledge Base Article Troubleshooting Management Console
Last modified: September 7, 2023
292
Why Imported Profile(s) from PCoIP Management Console 1.x/2.x to PCoIP Management Console 3.x cannot be applied? Status shows skipped.
Scenario Imported a profile from PCoIP Management Console 1.x /2.x  to PCoIP Management Console 3.x where firmware 6.0.0 is the only uploaded version in Settings -> Software. Pushing the profile to PCoIP Zero Clients results in a 'skipped' status.   Cause …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: September 19, 2023
294
Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card
Last modified: November 8, 2020
270
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 18, 2022
274
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
258
Wacom Cursor Offset with Autodesk Flame
Description : The Autodesk Flame by design introduces mouse offset when it is loaded. HP Anyware does not has an option to compensate for this offset in the Flame. As a result, users will see mouse offset in the Flame application.   Workaround : Since …
Knowledge Base Article Troubleshooting
Last modified: September 3, 2023
251
Why does traffic to my PCoIP Remote Workstation Card exceed the configured bandwidth settings?
Problem After setting the bandwidth limits on the PCoIP Remote Workstation Card in the PCoIP Remote Workstation Card AWI, excessive traffic is seen going to the PCoIP Remote Workstation Card from the PCoIP Zero Client. Cause PCoIP Remote Workstation …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: September 3, 2023
245