Updates to the Graphics Agent for Linux will be published on a regular basis. New stable builds will be produced approximately every three months.
To update the Graphics Agent to a new version, obtain the new installer and run it in place to replace the older version. Your configuration settings will be preserved.
Use the following three commands to complete the update:
You can remove the Graphics Agent for Linux from your system, or you can remove the repo config entirely.
To remove the package, open a console window and run the following command:
Before you proceed with installation, a few prerequisites must be met.
These instructions assume you have already built the remote desktop machine, and that the machine meets the agent's requirements.
The Graphics Agent for Linux must be assigned a valid PCoIP session license before it will work. Until you've registered it, you can't connect to the desktop using a Anyware client.
You receive a registration code when you purchase a pool of licenses from HP. Each registration code can be used multiple times; each use consumes one license in its pool.
Note: Disabling GSP
Before installing the Anyware Agent, install the correct driver for your configured GPUs. SSH into your machine and then proceed with the installation instructions below.
You can remove the Graphics Agent for Linux from your system, or you can remove the repo config entirely.
To remove the package, open a console window and run the following command:
Before you proceed with installation, a few prerequisites must be met.
These instructions assume you have already built the remote desktop machine, and that the machine meets the agent's requirements.
The Graphics Agent for Linux must be assigned a valid PCoIP session license before it will work. Until you've registered it, you can't connect to the desktop using a Anyware client.
You receive a registration code when you purchase a pool of licenses from HP. Each registration code can be used multiple times; each use consumes one license in its pool.
Important: Required ports will be automatically opened
The Graphics Agent for Linux installer will add firewall exceptions for the following required PCoIP ports during installation: TCP 443, TCP 4172, UDP 4172, and TCP 60443.