Anyware Clients are equipped to check for new updates and send notifications that appear as banners if an update is available. Clicking the banner redirects to the product download page, from where you can download the client installer.

1. Open Anyware Client, and click the Info icon in the top-left corner.

2. On Anyware Client | About pop-up, check if an update is available.

3. If an update is available, the Update now link will appear. Click this link to go to the product download page.

Upgrading the Anyware Software Client

Updates to the Anyware Software Client for Linux are published on a regular basis.

To upgrade to the latest version, use the following two commands:

Installing the Anyware Software Client for Linux

This topic contains instructions for installing the Anyware Software Client for Linux.

Before you begin, ensure that you have administrator privileges on the machine where you want to install the client.

Kernel Network Configuration

The pcoip-configure-kernel-networking.sh script is installed with the Anyware Software Client for Linux. This script tunes the kernel networking configuration to facilitate the network performance required by the Client. You need to run this script after installing the Anyware Software Client for Linux.

• To do that run the following command:

Uninstalling the Anyware Software Client

This section contains instructions for uninstalling the Linux client as well as removing the repo configuration. You might need to remove the repo completely if you are switching from one channel to another (for example, from beta to stable), before reconfiguring with the new repo.

Prerequisites for Installing the Software Client for Linux

There are a few prerequisites to complete before Anyware Software Client for Linux installation will work. The prerequisites are listed as follows:

• A desktop environment of your choice is required. Kubuntu distributions are bundled with KDE; you can install KDE from other distributions by using this command:

System Requirements

The following table outlines the system requirements for the Anyware Anyware Client for Linux:

Using Displays

When you connect to a PCoIP session, the Anyware Client for Linux shows your remote desktop as one or more displays. The number of displays it shows is constrained by your local system's available monitors (and the PCoIP protocol itself, which supports up to four monitors).

This section outlines how to configure your Wacom tablet through the Anyware Client session. There are two available features within the Anyware Client that can be used to configure the monitor display and orientation.

Selecting Audio Devices in Session

While in session, you can select audio devices that will be forwarded to the agent. If more than one audio device is connected to the client machine, you can select up to three audio input and output devices by default after a PCoIP session has been established.